SIGLENT SDM3055 Bedienungsanleitung PDF herunterladen (Seite 60)

SIGLENT Remote Manual

59 SDM3055/SDM3055A

2.9.5 [SENSe:]CURRent:{AC|DC}:RANGe:AUTO {OFF|ON|ONCE}

[SENSe:]CURRent:{AC|DC}:RANGe:AUTO?

Disables or enables autoranging for AC or DC current measurements.

Note:This parameter is not shared between AC and DC measurements. The parameters

are independent for AC and DC measurements.

Parameter Typical Return

{ON|1|OFF|0}，default ON 0 (OFF) or 1 (ON)

Configure AC current measurements and perform an immediate autorange.

Make and read two measurements:

CONF:CURR:AC

CURR:AC:RANG:AUTO ONCE

SAMP:COUN 2

READ?

Typical Response： +5.79294185E-06,+5.79294185E-06

 With autoranging enabled, the instrument selects the range based on the input signal.

 This parameter is set to its default value after a Factory Reset (*RST) or Instrument

Preset (SYSTem:PRESet).

2.9.6 [SENSe:]CURRent[:DC]:NPLC {<PLC>|MIN|MAX|DEF}

[SENSe:]CURRent[:DC]:NPLC? [{MIN|MAX|DEF}]

Sets the integration time in number of power line cycles (PLC) for DC current

measurements. Integration time is the period that the instrument's analog-to-digital (A/D)

converter samples the input signal for a measurement.

Parameter Typical Return

{0.3|1|10}，default 1

On the front panel, 0.3|1|10 corresponds to the Speed

menu under fast|middle|slow

+1.00000000E+01

Configure DC current measurements using a 10 PLC integration time.:

CONF:CURR:DC

CURR:DC:NPLC 10

 This parameter is set to its default value after a Factory Reset (*RST) or Instrument

Preset (SYSTem:PRESet).

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 96 97

Keine Kommentare

SIGLENT SDM3055 Bedienungsanleitung Seite 60