SIGLENT SDM3055 Bedienungsanleitung PDF herunterladen (Seite 38)

SIGLENT Remote Manual

37 SDM3055/SDM3055A

2.6.1 CONFigure?

Returns a quoted string indicating the present function, range, and resolution. The short

form of the function name (CURR:AC, FREQ) is always returned.

Parameter Typical Return

(none) “VOLT +2.00000000E-01”

Return the present function, range, and resolution.

CONF?

2.6.2 CONFigure:CONTinuity

Sets all measurement parameters and trigger parameters to their default values for

continuity measurements.

Parameter Typical Return

(none) (none)

Configure the instrument for continuity measurements.Then make a measurement using an

external trigger with positive slope (rising edge) and read the measurement:

CONF:CONT

TRIG:SOUR EXT;SLOP POS

READ?

 The range and resolution are fixed at 1 kΩ for continuity tests (a 2-wire resistance

measurement).

 The instrument beeps (if the beeper is enabled) for each measurement less than or

equal to the continuity threshold (The threshold can be passed by [: SENSe]:

CONTinuity:THReshold:VALue command ), and the actual resistance measurement

appears on the display.

 From 10 Ω to 1.2 kΩ, the instrument displays the actual resistance measurement

with no beep. Above 1.2 kΩ,the instrument displays "OPEN" with no beep.

 The FETCh?, READ?, and MEASure:CONTinuity? queries return the measured

resistance, regardless of its value.

 Use READ? or INITiate to start the measurement.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 96 97

Keine Kommentare

SIGLENT SDM3055 Bedienungsanleitung Seite 38