SIGLENT Remote Manual
81 SDM3055/SDM3055A
2.9.29 [SENSe:]VOLTage:{AC|DC}:RANGe:AUTO {OFF|ON|ONCE}
[SENSe:]VOLTage:{AC|DC}:RANGe:AUTO?
Disables or enables autoranging for AC and DC voltage measurements and for DC ratio
measurements.
Note:This parameter is not shared between AC and DC measurements. The parameters
are independent for AC and DC measurements.
Parameter Typical Return
{ON|1|OFF|0},default ON 0(OFF)or1(ON)
Configure DC voltage measurements and perform an immediate autorange.
Make and read two measurements:CONF:VOLT:AC
VOLT:AC:RANG:AUTO ONCE
SAMP:COUN 2
READ?
Typical Response: +8.36187601E-03,+8.34387541E-03
Under the condition of opening in automatic adjustment range, the instrument is
based on the input signal selection range.
This parameter is set to its default value after a Factory Reset (*RST) or Instrument
Preset (SYSTem:PRESet).
Kommentare zu diesen Handbüchern