SIGLENT Remote Manual
19 SDM3055/SDM3055A
2.3 CALCulate:TRANsform:HISTogram Subsystem
The HISTogram subsystem configures the histogram display. The instrument clears
histogram data when the measurement function changes and when any of the following
commands is sent:
CALCulate:TRANsform:HISTogram:CLEar[:IMMediate]
CALCulate:TRANsform:HISTogram:POINts
CALCulate:TRANsform:HISTogram:RANGe:AUTO
CALCulate:TRANsform:HISTogram:RANGe:{LOWer|UPPer}
CALCulate:TRANsform:HISTogram[:STATe]
INITiate[:IMMediate]
MEASure:<function>?
READ?
*RST
SYSTem:PRESet
Command Summary
CALCulate:TRANsform:HISTogram:ALL?
CALCulate:TRANsform:HISTogram:CLEar[:IMMediate]
CALCulate:TRANsform:HISTogram:COUNt?
CALCulate:TRANsform:HISTogram:DATA?
CALCulate:TRANsform:HISTogram:POINts
CALCulate:TRANsform:HISTogram:RANGe:AUTO
Example
This example enables an automatically scaled, 100-bin histogram of 1000 DCV
measurements. It then returns the computed histogram, including the lower and upper
range values, the total measurement count, and the bin data.
CONF:VOLT:DC 10,0.001
SAMP:COUN 1000
CALC:TRAN:HIST:RANG:AUTO ON
CALC:TRAN:HIST:POIN 100
CALC:TRAN:HIST:STAT ON
INIT
*WAI
CALC:TRAN:HIST:ALL?
Typical Response: +9.99383828E+00,+1.00513398E+01,+1000,<102 bin counts>
Note: The above response indicates 102 bin counts because the histogram includes bins
for values below and above the histogram range.
Kommentare zu diesen Handbüchern