SIGLENT SDS1000D Bedienungsanleitung PDF herunterladen (Seite 143)

135

Appendix A: Specifications

All specification applies to 10X probe and All the SDS1000 Series Digital

Storage Oscilloscopes.

To verify that the oscilloscope meets specifications, the oscilloscope

must first meet the following conditions:

●

The oscilloscope must have been operating continuously for thirty

minutes within the specified operating temperature.

●

You must perform the Do Self Cal operation, accessible through the

Utility menu, if the operating temperature changes by more than 5° C.

●

The oscilloscope must be within the factory calibration interval

All specifications are guaranteed unless noted “typical.”

Specifications

Inputs

Input Coupling AC, DC, GND

Input Impedance

1MΩ±2% || 16Pf±3Pf,

50Ω+/-2%(SDS1302CE/SDS1304CF/CFL,

SDS1202CE/SDS1204CF/CFL contain this function)

Maximum input voltage

400V （DC+AC PK-PK，1MΩ input impedance，

X10），CAT I

5Vrms；+/-10V Peak for 1S pulse, 50% duty cycle(50Ω

BNC) （ SDS1302CE/SDS1304CF/CFL ，

SDS1202CE/SDS1204CF/CFL contain this function）

Ch to Ch Isolation

(Both channels in same

V/div setting)

>100:1 at 150MHz: (SDS1302CE/SDS1304CF/CFL)

>100:1 at 100MHz: (SDS1202CE/SDS1204CF/CFL)

>100:1 at 70MHz (SDS1152CM)

>100:1 at 50MHz: (SDS1102C/CM/CE,

SDS1104CF/CFL)

>100:1 at 30MHz: (SDS1062C/CM/CE,

SDS1064CF/CFL)

>100:1 at 20MHz (SDS1042C)

>100:1 at 10MHz（SDS1022C）

Probe attenuator

1X、10X

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 153 154

Keine Kommentare

SIGLENT SDS1000D Bedienungsanleitung Seite 143