SIGLENT SDS1000D Bedienungsanleitung PDF herunterladen (Seite 102)

Table 2-50 Functional Menu of the Utility System 3:

Option Setting Introduction

Update

firmware

You can update the oscilloscope use USB flash

Driver (About need two minutes).

Pass/Fail Pres this button to enter the “Pass/Fail menu”.

Record Press this button to enter the waveform record

menu.

Setting/IP

Setting

Press this button to enter the “IO Setting

menu”(See table 2-51, support two channel

product) or “IP Setting menu” (See table 2-52,

support four channels product).

Next Page Page

3/4

Press this button to enter first page.

Table 2-51 IO Setting function menu:

Option Setting

Introduction

Baud

(SDS1000C/CM/CE)

300

2400

4800

9600

19200

38400

Set up band rate.

Table 2-52 IP Setting function menu:

Option Setting Introduction

IP Address Set oscilloscope IP Address, adopt LAN port

to connect the oscilloscope.

Subnet Mask

Set corresponding IP Subnet Mask.

Gate Way Set corresponding IP Gate Way.

Port Connect port,



dopt default Port.

Mac Address

The Hardware Address of the oscillscope

IP Setting

(SDS1000CF)

DHCP Dynamic host setup protocol, the default

setup is manual configure.

Note: (1) You can turn the “Universal” knob to adjust vaule and press the

“Universal” knob to switch the digit of IP Adress.

(2) Press the first option button on the right of the screen to switch setup

item.

(3) Press “SAVE/RECALL” key to save and press “SINGLE” key to

exit after you finishing IP setup.

(4) DHCP dynamic obtaining IP Adress action can be startup veritably

until DHCP is set to “Enable”, press “SINGLE” key to save and then

press “Save/Recall” key to exit . After three seconds, the screen enter

the IP setting menu again and you can see the new IP Adress.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 153 154

Kommentare zu diesen Handbüchern

Keine Kommentare

SIGLENT SDS1000D Bedienungsanleitung Seite 102

Kommentare zu diesen Handbüchern